BC Biomedical DPM-2100 Bedienungsanleitung PDF herunterladen (Seite 13)

Several indicators are provided to identify the current mode and/or status.

PRESSURE UNITS – Pressure units are indicated by an identifier bar. The RANGE key

will toggle the pressure units among PSI, mmHG, inH

O and cmH

O. The following is a

breakdown of the available pressure units and the measurement range for each:

Identifier Bar Pressure Units Range

PSIG -13.50 to 100.00

mmHg @ 20 °C -701 to 5190

inH

O 20 °C -374 to 2773

(flashing)

cmH

O 20 °C -951 to 7043

NOTE: If the measured pressure is outside of the range of the instrument, the display will

display -HI- or -Lo-.

TEMPERATURE UNITS (MODEL DPM-2100 ONLY) – The temperature can be

displayed in either degrees Celsius or Fahrenheit. When temperature is displayed, the

RANGE key will toggle the temperature units between Fahrenheit and Celsius.

Temperature Units Temperature Range

C (Celsius) 0.0 to 100.0 °C

F (Fahrenheit) 32.0 to 212.0 °F

NOTE: If the measured temperature is outside of the range of the instrument, the display

will display -HI- or -Lo-. If a probe is not connected, the display will show “no probe”.

LOW BATTERY – When the battery life reaches 10 percent, the display will show the

message “lo bat” for two seconds once every minute until the battery is replaced.

LINE POWER – The display will show “Line” instead of batter life remaining when the

meter is powered from the optional Battery.

DEF CAL – This status screen displays on Power Up if the unit is out of Calibration. The

unit will load default values, however the unit should be returned to BC Group for

Calibration.

DISPLAY INDICATORS

bar

no bar

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Keine Kommentare

BC Biomedical DPM-2100 Bedienungsanleitung Seite 13